Anti-Tip Device - GE JGB900 Owner's Manual & Installation Instructions

installation instructions
AWARNING
ANTI-TIP DEVICE
@
®
All ranges can tip and injury could
result.
To prevent accidental tipping of the range,
attach an approved Anti-Tip device to the
wall. (See Installing the Anti-Tip Device in
this section.) To check if the device is
installed and engaged properly, carefully
tip the range forward. The Anti-Tip device
should engage and prevent the range from
tipping over.
If you pull the range out from the wall for
may reason, make sure the Anti-Tip device
is engaged when you push the rmige back
agMnst the wall.
• For
VO/lI"
safety,
nevei" use v/)/li" Fange lol" WaI'uling
oF heating
tile
I'OOIll, Yo/II" ()veil and
cooktop
are
not designed to heat your kitchen.
Top
burnei_
should not be opei'ated without cookware on tile
grate. Such abuse could result ill fire and daulage
to your range and will void your warranw.
• Do not store or use couIbustible inatelJals,
gasoline or other flauunable wq)ors and liquids
in the vicinity of this or any other appliance.
Explosions or fires could result.
• Do
not use ()veil toF a storage area. ]teius stored in
tile oven can ignite.
• Do not let cooking grease or othei" flauinlable
uiaterials accuui ulate in or near the range.
LOCATION
Do not locate the rmage where it may be subject to
strong drafts. Any openings in the floor or wall behind
the rmage should be sealed. Make sure the openings
around the base of the range that supply fresh air for
combustion mad ventilation axe not obstructed by
carpeting or woodwork.
Your range, like ulany other household itenis, is
heavy and can settle into soft floor coverings such as
cushioned vinyl or carpeting. Use care when nioving
tile range on this type of flooring. It is i'ecolulnended
that tile tOlh)wing silnple and inexpensive instluctions
be tollowed to protect your floor.
Tile range should be installed on a sheet of plywood
(or siulilar niaterial), When the floor covering ends at
the fl'ont of the range, the area that the range will rest
on should be built up with plywood to tile saule level
or higher than the floor covering.
This will allow tile range to be nioved flir cleaning
or servicing. Pdso, ulake sure your floor covering will
withstand 180°F. (See tile Installation Safety Instructions
section.)
Make
sure tile
wall
coverings
_li'o/ind vo/u"
range C_lll
withstand tile heat generated (up tti 200°F) by tile
ran ,e (See tile
Installation
Safety Instructions
section.)
IMPORTANT!
Remove all tape mid packaging. Make sure the
burners are properly seated m_d level.
Take the accessory pack out of the oven mad/or
drawer,
Check to be sure that no range parts have come loose
during shipping.
42