Shelves - GE JGB900 Owner's Manual & Installation Instructions

Care and cleaning of the range.
Oven Shelves
If your o',en is equipped with nickel oven
shelves, they should be remo\vd fl'om tile
oven beflwe beginning tile seltXclean cycle.
To clean tile nickel sheers, use all abrasive
cleanse*: Mter cleaning, rinse the sheers
with clean water and dIw with a clean cloth.
If the sheers e\vr become haM to slide,
wipe tile shelf edges or oven shelf supports
with vegetable oil.
If your o\vn is equipped with gray porcelain-
coated shelves, they mm be cleaned in tile
oven chMng tile selgclean cycle.
They may also be cleaned by
using
all
abrasive cleanse_: _Mter cleaning, rinse tile
shelves with clean water and chw with a
clean cloth. If tile shelves e',vr _)ecome hard
to slide, wipe the shelf edges or o\vn shelf
supports with vegetable oil.
Wire cover holder.
Oven Light Replacement
CAUTION: B efore rep/aclbg yoa ovenh#htbuib,
disconnect thee/ectncai powerto therange at the
mainfuseorckcuitbraaker p ane/. B esuretoiet the
hghtcoverandbuibcoolcompiete/y
Tile oven light bulb is covered with a
relnox_0_le glass cover that is held ill place
with a bail-shaped wire. ]_elnove tile oven
dooi; if desired, to reach cover easily:
Toremove:
[_] Hold a hand under tile co;er so it
ii i
doesn't tifll when released. X,_ ith
fingeI_ of tile salne hand, finnl) push
back tile wire coxer holdei: Lift off
tile
COX er.
Do not remove any screws to remove
the cover.
] Do not touch hot bulb with a wet
cloth. Replace bulb with a 40-watt
household appliance bulb.
Toreplace cover:
[] Place it into the groove of the light
receptacle. Pull the wire torward to the
center of tile cover until it snaps into
place. _]lell ill place, tile wire holds
tile cover fiI_nh'. Be certain tile wire
is in the depression in the center of
tile cover.
Connect electrical power to tile range.
[]
38