Inserting A Standalone Unit Into A Running Stack; Viewing Device Health - Linksys SFE2000P - Managed Ethernet Switch Reference Manual
Fast ethernet switch
Hide thumbs
Also See for SFE2000P - Managed Ethernet Switch:
- Installation and administration manual (30 pages) ,
- Product data (4 pages) ,
- Reference manual (270 pages)
Table of Contents
Advertisement
Chapter
2
SFE2000/SFE2000P Gigabit Ethernet Switch Reference Guide
Inserting a Standalone Unit into a Running Stack
If a unit is in standalone mode, it will not participate in the Master Discovery process (it will not look for
a Stack Master and will not respond to master queries). As a result, it will not join the stack but will
continue to run as a standalone unit. The ports that are connected to the other units' stacking links will
not pass any traffic, and the Stack Master will consider them as failed stacking links and route all traffic
around them.
Viewing Device Health
The Health Page displays physical device information, including information about the device's power
and ventilation sources.
1. Click System > System Management > Health. The Health Page opens:
The Health Page contains the following fields:
•
Unit No. — Indicates the unit number for which the device information is displayed.
•
Power Supply Status — The power supply status. Power supply 1 is displayed as PS1 in the
interface, while the redundant power supply is displayed as RPS.
28
Health Page
Chapter 2:
Hide quick links:
Advertisement
Table of Contents
