Defining Trap Management
The Defining Trap Management section contains the following pages:
•
Defining Trap Settings
•
Configuring Station Management
•
Defining SNMP Filter Settings
Defining Trap Settings
1. Click System > SNMP > Security > Trap Management > Trap Settings. The Trap Settings Page
opens:
The Trap Settings Page contains the following fields:
•
Enable SNMP Notification — Specifies whether the device can send SNMP notifications. The
possible field values are:
–
Enable — Enables SNMP notifications.
–
Disable — Disables SNMP notifications.
•
Enable Authentication Notification — Specifies whether SNMP authentication failure notification
is enabled on the device. The possible field values are:
Chapter 11:
SFE2000/SFE2000P Gigabit Ethernet Switch Reference Guide
Trap Settings Page
Chapter
11
189