SET OA UID
•
Command:
SET OA UID [<bay number>] {ON | OFF}
•
Description:
Sets the Onboard Administrator UID on or off.
If you do not specify a bay number, the command defaults to the active Onboard Administrator.
•
Access level/Bay level:
All
•
Restrictions:
None
SET IPCONFIG
•
Command:
SET IPCONFIG {DHCP | STATIC} [<OA bay number>] [DYNAMICDNS] <ip address>
<netmask> [<gateway> [<DNS1address> [<DNS2 address>]]]
•
Description:
Configures IP settings for the Onboard Administrator to DHCP mode or static mode.
o
In STATIC mode, the IP address and Netmask are set to <ip address> and <netmask>
o
respectively. These settings take affect immediately. If the Gateway address and/or DNS
addresses are cleared, they are omitted. The Gateway and DNS address can also be set by
using the SET OA GATEWAY and ADD OA DNS commands.
SET IPCONFIG STATIC [<OA bay number>] <ip address> <netmask>
o
[<gateway> [<DNS1 address> [<DNS2 address>]]]
In DHCP mode, the IP address, Netmask, Gateway address, and DNS addresses are obtained
o
from the DHCP. This setting immediately takes affect. If DYNAMICDNS is specified, then the
DNS server is notified of the new IP address of the system when it is received from the DHCP
server.
SET IPCONFIG DHCP [<OA bay number>] [DYNAMICDNS]
o
•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
None
SET NTP POLL
•
Command:
SET NTP POLL <seconds>
•
Description:
Sets the polling interval of the NTP servers
Enclosure network configuration commands 94