CAUTION:
•
Command:
ENABLE EBIPA {SERVER|INTERCONNECT} [ALL | <bay number> [{ , | - } <bay
number>]]
•
Description:
Enables the Onboard Administrator to provide IP addresses to the devices in the bays using DHCP.
If you do not specify any bay numbers, then EBIPA is enabled for all bays.
DHCP traffic from iLO and the switch modules can no longer go outside the enclosure.
This causes a reset of the iLO, which causes it to attempt to get an IP address. The interconnect is
power-cycled.
•
Access level/Bay level:
Administrator, Operator
•
Restrictions:
Before using this command you must set up the EBIPA settings. This includes setting the initial IP
address, the netmask, and the default gateway.
REMOVE EBIPA
•
Command:
REMOVE EBIPA {SERVER|INTERCONNECT} DNS <ip address>
•
Description:
Removes the DNS server specified by the <ip address> from the list of DNS servers for either SERVER
bays or INTERCONNECT bays
•
Access level/Bay level:
Administrator, Operator
•
Restrictions:
The <ip address> and must be in the form ###.###.###.###, where each ### ranges from 0 to
255.
SET EBIPA
•
Command:
SET EBIPA { SERVER | INTERCONNECT }
•
Description:
Sets EBIPA settings for device or interconnect bays.
•
Access level/Bay level:
Administrator, Operator
•
Restrictions:
This command cycles power to the interconnect and causes a loss of connectivity.
Enclosure Bay IP Addressing commands 75