Unloading At The End Of A Cycle; Forget To Add A Dish - Baumatic BFD63SS Instruction Manual

BAUMATIC BFD63SS dishwasher user manual
WHAT YOU WILL SEE ON THE DISPLAY:
Washing Program: Intensive, Normal, Economic, Rinse,
Glass, Rapid and Pre-rinse.
Information Display: You can get information from
reading this: washing program, Error, Door-Open, etc.
Washing Phase: the 1 sign is pre-rinse; the 2
st
wash; the 3 is rinse and the last one is drying. They
rd
will run consecutively during the wash.
Note: there is no temperature display on Pre-rinse

FORGET TO ADD A DISH?

A FORGOTTEN DISH CAN BE ADDED AT ANY TIME BEFORE THE DETERGENT
DISPENSER OPENS.
OPEN THE DOOR A LITTLE TO STOP THE WASHING.
•
AFTER THE SPRAY ARMS STOP WORKING, YOU CAN OPEN THE DOOR
•
COMPLETELY.
ADD FORGOTTEN DISHES.
•
CLOSE THE DOOR, THE DISHWASHER WILL WORK AFTER TEN
•
SECONDS.
Need to Change the Cycle?
1. PRESS THE POWER SWITCH TO STOP WASHING
2. PRESS THE 'PROG.' BUTTON TO SELECT THE NEW PROGRAM
3. PRESS THE POWER SWITCH AGAIN TO START WASHING
Note
* – You may have to start a new cycle by reloading the detergent
if it has been a long time since the old cycle began. See page 12 to see
how to do this.
At the End of the Wash Cycle
At end of washing, the time display will flash for 8 seconds while the ALARM
sounds. The ALARM will not sound at the end of delayed washing,
however. We recommend you leave about ½ hour before unloading to
avoid injury and brittleness in dishware from heat.
State Information: the 1st sign means
the number of minutes remaining in a
wash. The 2nd sign means the delay
start time. The 3rd gives the
temperature.
Digital Display: shows the time remaining in a
wash, error codes, and the delay start time.
Choice of temperature. You can choose different
is main
nd
temperatures to change the intensity of the
wash.
14
14