Sharp FO 4400 - B/W Laser - All-in-One Service Manual page 9

7
Hold the toner cartridge by the handle and insert it into the print com-
partment.
•
Make sure the toner cartridge clicks into place.
•
The handle can be left standing up.
8
Close the print compartment cover.
9
Reset the drum counter by pressing
overlay), , and .
START/
3
ENTER
•
Note: The toner counter automatically resets each time you re-
place the toner cartridge. There is normally no need to reset the toner
counter manually. Should you find it necessary to manually reset the
LIFE
toner counter, press
V
START/
and .
ENTER
Note: The print compartment cover may become noticeably warm if a
large number of pages are successively printed. This is normal and does
not indicate a problem in the machine.
F
When to replace the toner cartridge
When the toner cartridge nears empty (about 100 pages can still be
printed), the toner cartridge indicator on the operation panel will blink.
When the toner cartridge is empty, the toner cartridge indicator will
light steadily and REPLACE TONER will appear in the display. Print-
ing will no longer be possible. Use the following replacement toner
cartridge.
Sharp FO-50ND toner cartridge
Hint:
When the toner cartridge nears empty, try taking it out of the ma-
chine and shaking it. This may increase the number of pages that
can be printed before the toner runs out.
G
When to replace the drum cartridge
When the drum cartridge nears the end of its life, the ALARM indica-
tor on the operation panel will blink and DRUM LIFE REACHED will
appear in the display. (this message appears when approximately
1000 pages can still be printed). Use the following replacement drum
cartridge.
Sharp FO-47DR drum cartridge
BLUE
GREEN
LIFE
(flip up the Rapid Key
V
(flip up the Rapid Key overlay),
4. Loading printing paper
You can load up to 250 sheets of letter or legal paper (max. 20 lbs.) in
the paper tray.
•
A paper cassette is available as an option. Up to 500 sheets of letter
or legal paper can be loaded in the paper cassette. To have the cas-
sette installed, consult your dealer.
Important: Do not use the back side of paper that has already been
printed on.
Note: If you need to add paper to the tray or cassette while paper still
remains, remove the remaining paper and combine it into a single
stack with the new paper.
1
Loading paper in the paper tray
Remove the received document tray.
2
Insert a stack of paper into the tray, print side up.
•
Important! The stack of paper must not be higher than the red line
on the paper tray.
3
,
2
Squeeze the paper guide and move it to match the length of the
paper you are loading.
Attach a letter or
legal label here to
indicate the paper size.
4
Replace the received document tray.
•
The received document tray must be attached for the fax machine
to operate properly.
1 – 6
Red line
FO-4400U
FO-CS1