Sharp FO 4400 - B/W Laser - All-in-One Service Manual page 13

8
Secure the plates with screws as shown. Use 6 mm screws for the
holes marked with "A", and 10 mm screws for the holds marked with
""P". Secure the screws in the order indicated by the numbers.
A3
A3
P3
A2
9
Replace the right side cover on the machine, inserting the tabs into
the holes.
Attach the longer cassette cover to the right side of the cassette,
inserting the tabs into the holes (first top, then bottom).
1
F
Replace the screws in the side cover on the machine.
Secure the cassette cover with two 10 mm screws.
A
A
P
P
A
A4
A4
A4
P4
A1
2
A
A
A
P
P
A
G
Attach the support plate to the left side of the machine, inserting the
top edges of the plate under the machine housing. Make sure that
the guides fit into the holes as shown.
Secure the plate with screws as shown. Use 6 mm screws for the
holes marked with "A", and 10 mm screws for the holes marked with
"P". Secure the screws in the order indicated by the numbers.
(Note that the top hole on the right does not require a screw.)
H
Attach the shorter cassette cover to the left side of the cassette, in-
serting the tabs into the holes (first top, then bottom).
I
Secure the cassette cover with two 10 mm screws.
J
Replace the rear cover (replace the screw under the small cover on
the left side of the rear cover first, and then replace the small cover).
1 – 10
1
2
P
P
FO-4400U
FO-CS1