Hardware Features - NETGEAR WNR3500v1 - RangeMax Wireless N Gigabit Router Setup Manual

Hardware Features

Before you install and connect your router, take a moment to become familiar with the front and
back panels of the router—especially the status lights on the front panel.
Front Panel
The lights on the front panel indicate the operating status of the router. A description of status light
behavior is included in
"Checking Basic Router Functions" on page
Figure 3
Back Panel
Figure 4 describes the port connections on the back panel of the wireless router.
Getting to Know Your Wireless Router
Figure 3. (For more information on interpreting the status lights, see
Power
On – Amber
On – Green
Blink – Amber
Blink – Green
Off
Internet
On – Amber
On – Green
Blink – Green
Off
Wireless
On – Blue
Blink – Blue
Off
LAN (Ports 1–4)
On – Green
Blink – Green
On – Amber
Blink – Amber
Off
WPS button/light
On – Green
Blink – Green
Blink – Amber
Off
30.)
The router is performing the power-on self-test diagnostic.
The power is on and the router is ready.
A software update is in progress.
TFTP firmware recovery is in progress.
Power is not being supplied to the router.
No IP address acquired.
The wireless router has acquired an Internet address.
Data is being communicated with the Internet.
No Ethernet cable is connected to the modem.
The wireless interface is enabled.
Data is being communicated over the wireless network.
The wireless interface is turned off.
The local port is connected to a 1000 Mbps device.
Data is being transmitted at 1000 Mbps.
The local port is connected to a 10/100 Mbps device.
Data is being transmitted at 10/100 Mbps.
No link is detected on this port.
WPS wireless security is being enabled.
Device is in the 2 minute interval to synchronize security.
There is an error in enabling WPS security.
WPS is not being set or enabled.
3