NETGEAR WNR3500Lv2 Installation Manual

Installation Guide
N300 Wireless Gigabit Router
WNR3500Lv2
Package Contents:
N E T G E A R
N300 Wireless Router
Ethernet cable Power adapter
Step 1:
Unplug the power
to turn off your modem.
DSL
or cable
Internet
Power On/Off
Modem
Step 4:
Connect the power adapter to
the router, then plug it into an
outlet. Wait until the wireless LED
turns solid blue.
If none of the LEDs turn on, make sure that
the Power On/Off button is in the ON position
(pushed in).
Step 2:
Connect one end of the yellow
Ethernet cable to your modem, and
the other end to the Internet port on
your router.
Power On/Off
N300 Wireless Router
Step 5:
Connect your computer
to the router.
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
Optionally, connect wirelessly by using the
preset wireless security settings
located on the bottom label.
Step 3:
Plug in, then turn on your modem.
Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
Laptop or Desktop
Computer
(not included)
Step 6:
Open a browser.
If the Web page does not display,
close and re-open the browser
and enter http://routerlogin.net in
the address bar, or check the
"Troubleshooting" section on
the back of this installation guide.