Table of Contents
Advertisement
Setting Up Your SC-T35
Positioning Your SC-T35
Step 3: Store Screws inside the Bracket
To store screws inside the bracket, please do the following:
NOTE
It's highly recommended to store screws inside the bracket when not needed
to prevent them getting lost.
1. Place a sheet of paper or a piece of cloth on a flat surface, and then put your bracket on that paper or cloth
with the screw storage side upward.
2. Place the screw upon its storage space, and push the screw into the space with your finger until it clicks
into place. For the smallest-size screw, use the tip of a screwdriver instead to push the screw.
NOTE
Please refer to the figure and descriptions in "Step 2: Understand Your Stand / VESA
Mount Kit for SC-T35"5" for the correct storage space of each screw.
Step 4: Remove Screws from the Bracket
To remove screws stored inside the bracket, please do the following:
1. Place a sheet of paper or a piece of cloth on a flat surface, and then put your bracket on that paper or cloth
with the screw storage side downward.
2. Insert the tip of a screwdriver into the square holes to remove the desired screws from the bracket.
10
Square Hole
Advertisement
Table of Contents
