Call Timer; Auto Standby; Ringer Volume (Shortcut); Flash/Call Waiting - RCA 2112 User 's guide User Manual

Call Timer

After you press the TALK/SPEAKER button on the handset, the built-in call
timer shows on the display and counts the length of time of the call in minutes
and seconds.

Auto Standby

If you place the handset in the cradle while the handset is off the hook (during
a call), the call is automatically disconnected.

Ringer Volume (Shortcut)

There are two ways to set the ringer volume. One is the traditional way as
described in the Programming Functions; Sound Setup; Ringer Volume menus.
The other one is this short cut to ringer menu.
1. Make sure the phone is OFF (not in TALK mode).
2. Press the #pause/ringer button to display SET RINGER LEVEL 5.
3. Use the caller ID-volume ( or ) button to scroll to your selection. LEVEL
5 is the default setting.
4. Press #pause/ringer button again to save and display the new selection
for a few seconds.

Flash/Call Waiting

If you subscribe to the combined Call Waiting Caller ID service from your local
telephone company, you will receive Caller ID information (if available) on Call
Waiting calls. During a phone call, you will hear a beep to indicate another call
is waiting on the line and Caller ID information for the waiting call shows on
the handset display.
• To connect to the waiting call, press the flash button on the handset, and
your o r i g i n a l call is put on hold.
• To switch between the two calls, press the flash button.

Last Number Redial

You may redial a number up to 20 digits long. To quickly redial the last number
you dialed:
1. Press the TALK/SPEAKER button.
2. Press the redial/format button.
-OR-
3. Press the redial/format button first , then use the caller ID-volume ( or )
button to select the desired redial number.
- Press the caller ID-volume (
the most recent calls (higher numbers).

) to review the oldest call and scroll toward