Table of Contents
Advertisement
4. Slip the mounting holes of the base (on bottom of unit ) over the wall plate
posts end slide the base down until the phone is firmly in place.
Answering System Setup
This section shows you how to set up your answering system to receive
incoming calls. Before you begin the set up process, you must turn on the
answering system.
1. Answering system has 3 modes RECORDS MSGS MODE, ANNOUNCE ONLY
MODE and OFF.
2. Press the answer mode button to switch to RECORDS MSGS MODE,
ANNOUNCE ONLY MODE and OFF.
NOTE: The answering system displays "- -" when it is off.
Answerer
On the Handset:
In the Answerer Menu, there are four programmable submenus:
Answerer Mode, Ring to Answer, Message Alert and Security Code.
1. Make sure your phone is OFF (not in TALK mode).
2. Press the mute/menu OK button to go to the main menu.
3. Press caller ID-volume ( or ) button to scroll to ANSWERER.
4. Press mute/menu OK button to enter the submenu.
Answer Mode
From the Answerer Menu:
1. Press the caller ID-volume (
Mode sub-menu.
2. Press mute/menu OK button to enter the menu. The screen displays
RECORD MSGS.
3. Use the caller ID-volume (
default setting is RECORD MSGS.
4. Press the mute/menu OK button to confirm. You will hear a confirmation
tone and the screen displays the new setting.
Handset Access
From the Answerer Menu:
1. Press the caller ID-volume ( or ) button to scroll to the Answerer Mode
sub-menu.
2. Press mute/menu OK button to enter the menu. The screen displays
ANSWER MODE RECORD MSGS.
or
) button to scroll to the Answerer
or
) button to scroll to your selection. The
Advertisement
Table of Contents
