Appendix E: Step - By -Step Virtual Wan Configuration - Efficient Networks SpeedStream 5100 Series User Manual

Step-by-Step Virtual WAN Configuration
There are several steps to configuring a virtual WAN connection. To make it easier to follow, this section
presents the steps that are detailed in 5: Customizing Router Settings | WAN Interface Configuration
Wizard | Add a New Virtual Connection (VC) on page 31.
Shaded rows indicate that these steps are repeated if you select multiple PPPoE sessions to configure in
the PPPoE Session Count window.
Step On this window:
1
Web Management
Interface
2 Current Configuration
3 Protocol Selection
4a This step is dependent on your choice of protocol. Click the protocol type to jump to the specific
configuration procedures.
4a RFC-2684 Bridged protocol
4b RFC-2684 Bridged/IP protocol
4c RFC-2684 Routed protocol
4d PPPoE protocol
4e PPPoA protocol
4a. If you selected the RFC-2684 Bridged protocol:
Step On this window:
4a Connection Name
5 VC Wizard
4b. If you selected the RFC-2684 Bridged/IP protocol:
Step On this window:
4b
2684 Bridged
5
2684 PPPoE
6 Interface Options
7
Connection Name
Do this:
On the main menu, click Setup, then click WAN Interface.
At the bottom left corner of the window, click Add a new VC.
If the ATM Settings window displays next, click Next to continue to
Note
the Protocol Selection window.
Select protocol: RFC-2684 Bridged, Bridged with IP, or Routed; PPPoA;
PPPoE.
Do this:
Enter connection name
Finish
Do this:
Enter Internet Protocol information as provided by your service provider.
Specify if connection will also use PPPoE.
Select interface options: firewall, attack detection system, universal plug
and play; RIP; NAT/NAPT.
Enter name to use for this connection.
110
SpeedStream Router User Guide
Appendix E: