Ip Rip Authentication Mode - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip rip authentication mode

ip rip authentication mode { text | md5 }
no ip rip authentication mode
Syntax Description
text
md5
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface vlan2
Switch(config-if)# ip rip authentication mode md5
CLI Reference Guide
To configure the type of authentication used in Routing Information Protocol
(RIP) Version 2 packets, use the ip rip authentication mode command in
interface configuration mode. Use the no form of the command to disable the
authentication function.
Clear text authentication.
Keyed Message Digest 5 (MD5) authentication.
Clear text authentication (text)
Interface configuration
Only VLAN interfaces at which IP addresses are configured are valid interfaces
for this command.
RIP Version 1 does not support authentication. This command only affects
RIPv2.
The following example shows how to configure the authentication mode of the
interface to md5 at interface VLAN 2:
Verify the settings by entering the show ip rip interface command.
ip rip authentication mode
305