Ip Rip Authentication Mode - D-Link DES-7200 Cli Reference Manual

Chapter 31 RIP Configuration Commands
Related
commands
Platform
description
Version
description

31.1.10 ip rip authentication mode

Use this command to define the RIP authentication mode in the interface configuration
mode. The no form of this command is used to restore it to the default RIP authentication
mode.
ip rip authentication mode {text | md5}
no ip rip authentication mode
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
31-12
Command
ip rip authentication
mode
ip rip receive version
ip rip send version
key chain
Parameter Description
text Enable plaintext authentication.
md5 Enable MD5 authentication.
It is the plaintext authentication by default.
Interface configuration mode.
To exchange RIP routing information directly, all devices must have
the same RIP authentication mode. Otherwise, the RIP packet
exchange will fail.
The RIPv1 does not support RIP authentication but the RIPv2 does.
DES-7200 CLI Reference Guide
Description
Define the RIP authentication mode.
Define the version of RIP packets received
on the interface.
Define the verion of RIP packets sent on
the interface.
Define the keychain and enter into the
keychain configuration mode.