DGS-3620 m/ mSW Rls. 1.02.000
13-3 ip rip authentication mode
ip rip authentication mode text
no ip rip authentication mode
Syntax
Description
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# ip rip authentication mode text
CLI Reference Guide
Use this command to configure the simple password authentication type used by
RIP interface. Use the no form of this command to restore to the default value.
None.
By default no-authentication is used by RIP interface.
Interface configuration mode.
RIP Version 1 does not support authentication. To exchange RIP routing
information directly, all devices must have the same IP authentication mode;
otherwise, the RIP packets exchange will fail.
You can verify your settings by entering the show ip rip or show ip rip interface
command.
Set System interface (vlan 1) to use simple password authentication:
ip rip authentication mode
418