Using The Reset Button - Cisco AIR-WLC2106-K9 - Wireless LAN Controller 2106 Quick Start Manual

Figure 5 Access Points Connected to a Controller
Cisco 2106 wireless
LAN controller
Cisco Access Points
Checking the Controller LEDs
If your controller is not working properly, check the LEDs on the front panel of the unit. You can use
the LED indications to quickly assess the unit's status. See Figure 2 on page 5 for a description of the
front panel LEDs.
The installation is complete. Refer to the Cisco Wireless LAN Controller Configuration Guide for
more information about configuring your controller. The guide is available on cisco.com.

Using the Reset Button

The Reset button on the controller's back panel becomes active after the controller boots. Follow these
steps to reset the controller using the Reset button:
Connect a PC to the controller console point.
Step 1
Press and hold the Reset button for at least 3 seconds using a pointed object, such as a ball
Step 2
point pen, pencil, or paper clip.
Network
10/100BASE-T
MDI cable
10/100BASE-T
MDI cables
19