Starting Up - NEC POWERMATE PRO2180 - SERVICE MANUAL 1996 Service Manual

2-8 Setup and Operation
Power on the speakers after the operating system has been loaded. To operate your
speakers push the power button on the front of the right speaker and adjust your volume
control.
This completes setup procedures. Continue to the "Windows NT 3.51 and Driver
Installation" instructions to load the operating system.

STARTING UP

Press the power button (see Figure Section 2-9) to power-on the system. The power lamp
lights green, indicating that the system is on.
The system automatically goes into its Power-On-Self-Test (POST), and checks system
components. One beep indicates that the system has successfully completed the POST.
If a problem occurs, a series of beeps may sound. If this happens repeatedly after powering
on, power off the system and Troubleshoot.
If a problem occurs and is not indicated by beeps, power off the system and troubleshoot.
NOTE: If the system displays a message
indicating that system settings have changed, run
Setup (see "System Configuration" later in this
section).
Figure Section 2-9 Power Button