Converting Model G0623X3 To 440V - Grizzly G0623X Owner's Manual

Converting Model
G0623X3 to 440V
The Model G0623X3 is prewired for 220V 3-
phase operation, but it can be rewired for 440V
operation.
To complete this conversion procedure, you must
buy a 440V magnetic switch and rewire the motor
for 440V operation. A 440V magnetic switch can
be purchased from Grizzly by calling 1-800-523-
4777. Refer to the parts breakdown in the back
of this manual to find the correct 440V magnetic
switch for your machine.
This rewiring job must be inspected by a quali-
fied electrician before the saw is connected to the
power source. Also, the junction box on the motor
can be accessed easier for rewiring if the blade is
moved to 0˚ (90˚ to table) before beginning.
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the setup pro-
cess. DO NOT connect the machine to the
power source until instructed after setup.
G0623X/G0623X3 10" Sliding Table Saw
To rewire the machine for 440V operation:
1. DISCONNECT SAW FROM POWER!
2.
Remove the cover of the magnetic switch.
3.
Disconnect all the wires from the incoming
power cords.
4.
Remove the magnetic switch and install the
new magnetic switch in the same manner
as the old switch was installed. Refer to the
wiring diagram on Page 58 if you need help
remembering where the wires are attached.
5. Remove the cabinet cover from the back of
the machine.
6.
Rewire the motor to 440V as shown in the
diagram on Page 58.
7.
Replace the junction box cover, cabinet door
cover, and magnetic switch cover.
-17-