Dust Hose Support - Grizzly G0623X Owner's Manual

39. Install the hose support, as shown in Figure
44, with hardware shown below.
�����������
����
�����������
�������
�������
����
�������
���������
������������
Figure 44. Hose support installed.
DO NOT operate this saw without an ade-
quate dust collection system. This saw cre-
ates substantial amounts of wood dust while
operating. Failure to use a dust collection
system can result in short and long-term
respiratory illness.
Minimum CFM at 5" Dust Port:
Minimum CFM at 2 ⁄
1
2
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust col-
lector, (2) hose type and length between the
dust collector and the machine, (3) number
of branches or wyes, and (4) amount of other
open lines throughout the system. Explaining
how to calculate these variables is beyond the
scope of this manual. Consult an expert or pur-
chase a good dust collection "how-to" book.
G0623X/G0623X3 10" Sliding Table Saw
Hose
Support
�����
����
���������
�����
625 CFM
" Dust Port: 150 CFM
40. Secure a 5" dust hose to the dust port located
under the saw table (Figure 45).
Figure 45. 5" dust port location.
41. Attach a 2½" dust hose to the blade guard
dust port, as shown in Figure 46.
Figure 46. 2½" Dust port location.
42. Run the 2½" hose over the hose support, as
shown in Figure 47.
Figure 47. Dust hose support in use.
-31-