Cisco CISCO2515-RF - 2515 Router User Manual page 65

Configure the second synchronous serial interface, for example, as follows:
Step 3
Configuring interface Serial1:
Is this interface in use? [yes]:
Configure IP on this interface? [yes]:
Configure IP unnumbered on this interface? [no]:
IP address for this interface: 172.16.74.2
Number of bits in subnet field [8]:
Class B network is 172.16.0.0, 8 subnet bits; mask is
255.255.255.0
Configure AppleTalk on this interface? [no]: yes
AppleTalk starting cable range [3]: 5
AppleTalk ending cable range [4]: 5
AppleTalk zone name [myzone]: ZZ Serial
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [3]: B003
Step 4 The configuration you entered is now displayed and you are asked if you want
to use the displayed configuration. If you enter no, you will lose the
configuration information you just entered and you can begin the configuration
again. If you enter yes, the configuration will be entered and saved in the startup
configuration:
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this
configuration.
Press RETURN to get started!
Proceed to the section "Cisco IOS Software Basics" for more information about the
Cisco IOS software.
Configuring the Router for the First Time
Configuring the Router 4-11