Cisco CISCO2515-RF - 2515 Router User Manual page 63

Configure AppleTalk on this interface? [no]: yes
Configure IPX on this interface? [no]: yes
After you have completed the entire initial router configuration using the System
Configuration Dialog, proceed to the section "Configuring ISDN," later in this chapter, for
additional ISDN configuration information.
Configuring Ethernet or Token Ring Interfaces
The Ethernet and Token Ring interfaces are configured to allow connection to a LAN. To
configure the interface parameters, you need to know your Ethernet or Token Ring interface
network addresses.
Take the following steps to configure an Ethernet or Token Ring interface to allow
communication over a LAN:
Step 1
Step 2
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]: 1
AppleTalk ending cable range [1]: 2
AppleTalk zone name [myzone]:
AppleTalk additional zone name: otherzone
AppleTalk additional zone name:
IPX network number [1]: B000
Press Return or enter yes to configure the LAN interface:
Configuring interface Ethernet0:
Is this interface in use? [yes]:
Determine which protocols you want to support on the LAN interface and enter
the appropriate responses. In the following example, the system is configured for
IP, AppleTalk, and IPX:
Configure IP on this interface? [yes]:
IP address for this interface: 172.16.72.1
Number of bits in subnet field [8]: 8
Class B network is 172.16.0.0, 8 subnet bits; mask is
255.255.255.0
Configuring the Router for the First Time
Configuring the Router 4-9