D-Link SECURICAM Network DCS-2120 User Manual page 71

Section  - Configuration
You need to login the first time when you start the Launcher. The authentication window is shown below. If you do not
have an account, the monitor tool will not execute. You must log in as admin (administrator) to use this application.
Enter the password for the administrator.
Note: The password is the one you provided during installation.
In the Monitor program, the admin has the right to access the DCS-2120 Network Camera through this application
software and change the local settings as well. But the admin password for the software is not the same as the admin
password for the Internet camera. You can change the settings of each selected Internet camera from the Monitor
program only if you have the admin password for the Internet camera.
If you have the admin privilege, you have the right to do the following tasks:
• Run the configuration tool
• Change the recording schedule
• Change the local settings
Again, if you need to change the settings of the DCS-2120, you must have the administrator's password for the camera itself.
D-Link DCS-10 User Manual
Logging In
The Admin Privilege
1