D-Link SECURICAM Network DCS-2120 User Manual page 34

Section  - Configuration
Access name:
RTSP port:
SSID:
Wireless Mode:
Channel:
TX Rate:
Security:
Auth mode:
Key length:
D-Link DCS-10 User Manual
This option allows the user to specify the file name for RTSP streaming.
This option allows the user to set a port other than the default UDP port 554.
(Service Set Identifier) is a name that identifies a wireless network. Access Points and wireless clients
attempting to connect to a specific WLAN (Wireless Local Area Network) must use the same SSID. The
default setting is dlink.
Click on the drop-down menu; select from the following options:
Infrastructure - connecting the WLAN using an Access Point such as the DWL-2100AP or a DI-624
wireless router.
Ad-Hoc – wireless mode used when connecting directly to a computer equipped with a wireless adapter
in a peer-to-peer environment.
Under Infrastructure mode, the wireless channel is automatically selected by the camera. Under Ad-Hoc
mode, the default wireless channel setting is channel 6. Select the channel that is the same as the other
wireless devices on your network.
Select the transmission rate on the network. Auto is the default setting.
Select the encryption type from the drop-down list. The default setting for the encryption is None, which
means the security is disabled.
If the encryption type selected is WEP from the Security drop-down list, choose one of the authorization
modes:
Open - communicates the key across the network.
Shared – allows communication only with other devices with identical WEP settings.
Select the key length, either 64 bits or 128 bits