Table of Contents
Advertisement
Troubleshooting – Frequently Asked Questions
My CLIE handheld displays the message "Waiting for sender"
when it is near my computer's infrared port.
, Your computer's infrared port may be set to search automatically for
the presence of other infrared devices. Do the following to turn off
this option:
1
In the Windows task bar, select Start, point to Settings, and then
select Control Panel.
2
Double-click Infrared.
3
Click the Options tab.
4
Clear the selection of the option "Search for and provide status for
devices within range."
5
Click Apply and OK.
, Move your CLIE handheld away from the computer's infrared port.
, Make sure that you turn the Beam Receive function off.
I cannot cancel a HotSync operation midway.
, You may not be able to cancel a job a few seconds after you start a
HotSync operation via a USB connection. Wait for a while and try
again.
I cannot backup some data at a HotSync operation.
, Some data is designed not to be backed up by a HotSync operation.
When I tap the HotSync button on the cradle, nothing
happens on the Palm Desktop for CLIE software and my CLIE
handheld times out.
, Check the Palm Desktop for CLIE software HotSync Setup options to
confirm that you have the correct settings for local HotSync
operations.
, Close and restart HotSync Manager and USB Switcher on your
computer.
Chapter6
Additional information
Continued on next page
198
Advertisement
Table of Contents
