Makita HR2641X1 Instruction Manual page 5

1
015337
To turn on the lamp, pull the trigger. Release the trigger
to turn it off.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
Do not use thinner or gasoline to clean the lamp.
•
Such solvents may damage it.
Reversing switch action
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
For Model HR2631F, HR2631FT, HR2320T, HR2630,
HR2630T
CAUTION:
If the switch trigger can not be depressed, check
•
to see that the reversing switch is fully set to
position (A side) or
1
015338
This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to
the position (A side) for clockwise rotation or
the position (B side) for counterclockwise rotation.
1. Lamp
(B side).
1. Reversing
switch lever
B
A
For Model HR2641
1
A
015361
NOTE:
When you operate the tool in counterclockwise
•
rotation, the switch trigger is pulled only halfway
and the tool
counterclockwise rotation, you cannot push in the
lock button.
This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to
the position (A side) for clockwise rotation or
the position (B side) for counterclockwise rotation.
Changing the quick change chuck for SDS-
plus
For Model HR2631FT, HR2320T, HR2630T
The quick change chuck for SDS-plus can be easily
exchanged for the quick change drill chuck.
Removing the quick change chuck for SDS-plus
CAUTION:
Before removing the quick change chuck for SDS-
•
plus, always remove the bit.
3
1
2
015339
Grasp the change cover of the quick change chuck for
SDS-plus and turn in the direction of the arrow until the
change cover line moves from the
symbol. Pull forcefully in the direction of the arrow.
5
1. Reversing
switch lever
B
runs at half speed.
1. Quick change
chuck for SDS-
plus
2. Change cover
line
3. Change cover
symbol to the
For