Extension Cords - Makita 7104L Instruction Manual

18. NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped
or
if the cutting tool is accidentally contacted.
19. CHECK DAMAGED PARTS. Before further u s e of the tool, a guard or other
part that is damaged should b e carefully checked to determine that it will
operate properly and perform its intended function - check for alignment
of moving parts, binding of moving parts, breakage of parts, mounting, and
any other conditions that may affect
its
operation. A guard or other part that
is
damaged should b e properly repaired
or
replaced.
20. DIRECTION OF FEED. Feed work into a blade or cutter against the direction
of rotation of the blade or cutter only.
21. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Don't
leave tool until it c o m e s t o a complete stop.
2 2 . PROPER GROUNDING. This tool should b e grounded while in u s e t o protect
the operator from electric shock.
23. EXTENSION CORDS:
Use only three-wire extension cords which have three-
prong grounding-type plugs and three-pole receptacles which accept the
tool's plug. Replace or repair damaged
or
worn cord immediately.
VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,
outlet, etc.) b e sure the voltage supplied
is the s a m e as that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY t o the user - a s well a s damage t o
the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with
voltage less than the nameplate rating is harmful t o the motor.
3