Makita DA3011FJ Instruction Manual page 5

Reversing switch action
1
A
003796
CAUTION:
Always check the rotational direction before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. It will damage the tool to
change the rotational direction before the tool
stops.
This tool has a reversing switch to change the rotational
direction. Move the
the position (A side) for clockwise (forward) rotation or
the position (B side) for counterclockwise (reverse)
rotation.
Lighting up the lamps
4
5
1
003795
For Model DA3010F, DA3011F
CAUTION:
Do not look in the light or see the source of light
•
directly.
To turn on the lamp, start the tool. Then, the lamp lights
up the top of the bit. To turn it off, stop the tool.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
1. Reversing
switch lever
1
B
reversing switch
1. Lamp
2. Speed control
screw
3. Switch lever
4. Higher
5. Lower
3
2
Installing side grip (handle)
003797
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Screw the side grip on the tool securely. The side grip
can be installed on either side of the tool, whichever is
convenient.
Installing or removing drill bit
For Model DA3010, DA3010F
lever to
003798
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in
just one hole, then loosen the chuck by hand.
After using the chuck key, be sure to return to the original
position.
For Model DA3011, DA3011F
1
2
004649
Hold the ring and turn the sleeve counterclockwise to
open the chuck jaws. Place the bit in the chuck as far as it
will go. Hold the ring firmly and turn the sleeve clockwise
to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve
counterclockwise.
5
1. Chuck key
1
1. Sleeve
2. Ring