Makita GVU01SM Instruction Manual page 9

3. Align the hole in the middle handle with the
hole in the upper handle, then insert the bolt from the
inside, and then tighten the thumb nut from the outside.
Perform the same procedure on the other side.
4
Fig.2
► 1. Upper handle 2. Thumb nut 3. Bolt 4. Middle
handle
NOTE: Make sure that the cord is not caught between
the handle and the thumb nut.
Fig.3
1
2
3
Installing or removing the grass
basket
To install the grass basket, follow the steps below.
1. Open the rear cover.
Fig.4
► 1. Rear cover
2. Hold the handle of the grass basket, and then
install the grass basket by inserting the rod of the grass
basket into the grooves on the machine as shown in the
figure.
3
Fig.5
► 1. Grass basket 2. Handle 3. Rod
To remove the grass basket, open the rear cover, and
then remove the grass basket by holding the handle.
9 ENGLISH
1
2
1
3