Makita GVJ02 Instruction Manual page 13

To install, insert the rip fence into the rectangular hole on the side
of the base with the fence guide facing down. Slide the rip fence to
the desired cutting width position, then tighten the bolt to secure it.
1
2
Fig.25
► 1. Hex wrench 2. Bolt 3. Fence guide 4. Rip fence (Guide rule)
Circular cuts
When cutting circles or arcs of 170 mm (6-11/16") or
less in radius, install the rip fence as follows.
1
Fig.26
► 1 . Rip fence (Guide rule)
CAUTION:
Do not touch the tip of the circular
guide pin. The sharp tip of the circular guide pin can
cause injury.
1.
Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
2. Insert the circular guide pin through either of the two
holes on the fence guide. Screw the threaded knob onto
the circular guide pin to secure the circular guide pin.
5
2
Fig.27
► 1 . Threaded knob 2. Fence guide 3. Rip fence
(Guide rule) 4. Circular guide pin 5. Bolt
3. Slide the rip fence to the desired cutting radius,
and tighten the bolt to secure it in place.
NOTE: Always use jig saw blades No. B-17, B-18,
B-26 or B-27 when cutting circles or arcs.
Guide rail adapter set
Optional accessory
When cutting parallel and uniform width or cutting
straight, the use of the guide rail and the guide rail
adapter will assure the production of fast and clean
3 cuts. To install the guide rail adapter, insert the rule bar
into the rectangular hole on the side of the base as far
4
as it goes. Secure the bolt with the hex wrench securely.
1
3
Fig.28
► 1 . Hex wrench 2. Rule bar 3. Bolt
Insert the rule bar into the square hole of the guide rail
adapter, and secure the screw firmly. Place the guide
rail adapter on the guide rail.
3
Fig.29
► 1 . Guide rail adapter 2. Guide rail 3. Screw
NOTICE:
B-16, B-17 or 58 when using the guide rail and the
guide rail adapter.
1
3
4
13 ENGLISH
Always use jig saw blades No. B-8, B-13,
2
1
2