Pulse Mode Function - AEG AMLLGN Original Instructions Manual

PULSE MODE FUNCTION

For outdoor work under direct sunlight or bright conditions and for extended indoor ranges
of up to 50 m / 164 ft., use the pulse mode with a detector.
A detector is not included and must be purchased separately.
When the pulse mode is activated, the laser beams will fl ash at a very high frequency
(invisible to the human eye). This will allow the detector to locate the laser beams.
1
The pulse mode can be
activated in self-leveling
mode (A) or manual mode (B).
If the P button is pressed, the
green LED next to it will light
up.
2
When the pulse mode is turned
on, the visibility of the laser
beams are slightly reduced.
For information on how to
operate the detector, refer to
the operating instructions for
the detector.
3
To turn off the pulse mode,
press the P button again, and
the green LED near it will turn
off .
For sign-off review, sent 4 Aug 2023.
A
A
B
B
17
17
8