Accuracy Check - AEG AMLLGN Original Instructions Manual

ACCURACY CHECK

The product is factory calibrated. AEG recommends the user to check the accuracy of
the laser periodically, especially if the product falls or is mishandled.
If the maximum deviation of the laser is exceeded in one of the accuracy checks,
contact one of our AEG service agents (see our list of guarantee/service addresses).
Do the following accuracy checks to ensure optimum performance of the product:
1. checking the height accuracy of the horizontal beam
2. checking the leveling accuracy of the horizontal beam
3. checking the leveling accuracy of the vertical beam
4. checking the 90º accuracy between the two vertical beams
5. checking the plumb accuracy
Before checking the laser accuracy and after mounting the product on the tripod, check
the leveling of the tripod.
1
CHECKING THE HEIGHT ACCURACY OF THE HORIZONTAL
BEAM (UP AND DOWN DEVIATION)
1. Set up the product on a tripod or on a  at surface
between two walls, A and B, approximately 5 m apart.
2. Position the product approximately 0.5 m from wall A.
3. Turn on the self-leveling mode and press the button to project the horizontal and the
vertical cross beams towards wall A.
4. Mark the centre of the cross beams on the wall as a1.
A
a1
18
ENGLISH
For sign-off review, sent 4 Aug 2023.
18
B