Ddns Setting - Honeywell HICC-1600TVI Operation Manual

Subnet Mask: Input the corresponding IP subnet mask
Default Gateway: Input the corresponding gateway address
DNS 1: DNS server IP address
DNS2: DNS server standby IP address
SNMP: To detect whether it will cause any management attention as device connected on the network
SNMP Manager IP:
HTTP Port: Input the corresponding port ( Default is 80)
HTTPS Port: Input the corresponding port ( Default is 4433)
Enable PPPOE: When click Enable PPPOE, the device and HTTP port will mapping to the router automatically
Multicast Add： Input the corresponding multicast address
Multicast Port：Input the corresponding multicast port (Default is 28080)
Device Port: Input the corresponding device port (Default is 5050)
Enable PPPOE: Click to enable PPPOE server
PPPOE server: Input the PPPOE server number
Username: Input the username
Password: Input the password
Confirm pwd: Input the password again to confirm it
After all parameters setting completed, click "Save" and the it comes into effect immediately.

DDNS Setting

DDNS is implemented through a dynamic domain resolution server. It requires a PC with fixed IP address on the Internet, on which
the dynamic domain resolution server runs. IP Camera network setting interface as below:
Enable DDNS: Click to determine whether to use Dynamic Domain Name Server
Server Type: Select DDNS server type (There are Dyndns/ PeanutHull/ NO-IP/ 3322/ DnsDynamic five types selectable)
Server Name: Input server name, for example, member.3322.org
Port: Input port No.
Username: Input user name
Password: Input password
Confirm pwd: Input the password again to confirm it
Domain: Input the standby domain
After all parameters setting completed, click "Save" and the it comes into effect immediately.
Input the corresponding SNMP manager IP address
Figure 3-20
Honeywell
17