Makita JM21000330 Manual page 3

ENGLISH (Original instructions)
1. Up blade bracket
2. Bolt A
3. Square section of knob
4. Lug
5. Lifting bracket groove
Assembly
1. Remove blade.
2. Loosen bolt A using hex wrench. (Fig. 1 & 2)
3. Remove up blade bracket. (Fig. 1 & 2)
4. Loosen nut. (Fig. 7)
Fit lugs (2 points) and square section of knob of belt
sanding attachment into groove of lifting bracket, and
secure using knob A in the position shown in the
diagram. (Fig. 3)
5. Lift up protector plate, and temporally latch in support
plate. Make sure the support plate soffit fits into table
insert groove, and tighten nut to secure. (Fig. 4, 5 & 7)
6. Mount sanding belt. (Fig. 6)
Note:
• Maximum height of material not to exceed 120 mm.
• Use a sanding belt that is 2,240 mm long and 20 mm
wide or less.
• As shown in the diagram, move away the guide bearing
and slide bearing from the sanding belt. (Fig. 8)
Explanation of general view
6. Knob A
7. Protector plate
8. Support plate
9. Support plate soffit
10. Table insert groove
11. Sanding belt
12. Nut
13. Spring washer
14. Washer
15. Square neck screw
3