Troubleshooting - Honeywell VC14 AEROMAX ELITE User Manual

TROUBLE SHOOTING
1. When the filter is not installed properly in place or
is missing, the filter icon flashes (flashing duration
10 seconds), and the filter icon goes out after it is
installed. Follow the steps on page 17 of this user
manual to re-insert the filter.
2. When the air duct is blocked or the dust cup is full, the
duct icon will always flash, and the battery icon will be
displayed at the same time, and the light band will be
all white. The dust cup needs to be cleaned, and the
whole machine needs to be restarted. Follow the steps
on page 17 of this user manual to clean the dust cup.
3. If the brush needs to be cleaned, the brush icon will
flash while running and the light band will be all white.
It is necessary to check the condition of brush roll and
restart the whole machine. Follow the steps on page
16 of this user manual to clean the roller brush.
4. If the floor roller brush is blocked, the machine will stop
running, the brush icon light will flash for 10 seconds,
the other lights will be off, and the light band will be all
white. Follow the steps on page 16 of this user manual
to clean the roller brush.
5. If you turn on the machine in an area with a low
concentration of dust, and the LED display always
shows a full red light band which indicates a high
concentration of dust, please wipe off the dust on the
infrared sensor lamp.
Cleaning the
5
Infrared sensor lamp
Infrared
Sensor lamps
EN | 18
Filter icon flashes
Machine needs
to be restarted
%
ECO
Brush icon flashes
Brush icon
flashes 10
seconds
1
2
3
4