Troubleshooting; Warranty - Honeywell F-HE User Manual

TROUBLE SHOOTING
Repair or service of electrical components such as cord or motor, must only be carried out by an
authorized service center.
Vacuum does not start:
Motor stops:
Suction power is reduced:
Static shocks:

WARRANTY

Warranty covers:
This vacuum cleaner is warranted for one (1) year. This warranty includes spare parts and labor costs, and
covers manufacturing and material defects that may occur during normal domestic use. This warranty does
not include normal wear and tear.
Service under this warranty will only be performed with proof that the defect occurred within the warranty
period and that the vacuum cleaner was purchased as a new product. Proof will be a cash register receipt
with date and product type.
Warranty does not cover:
Normal wear and tear of accessories and filters.

Defects or damage occurring as a direct or indirect result of incorrect use - such as the vacuuming of

rubble, or carpet deodorant powder (read safety warnings and instructions)
Abuse due to failure to follow instructions in the user manual.

 Incorrect or poor configuration, i.e. setting up or improper connection, fire-damage, fire, lightning
strike or unusual voltage fluctuations or any other electrical disturbances. Electrial disturbanses
include a defective circuit breaker or defective electrical installations on the supply grid.
11
 Check to see that the plug is correctly inserted in the electrical outlet
and that there is power at receptacle.
 A circuit breaker may have tripped. Check the circuit breaker box.
 The cord or plug may be damaged. Call the Customer Service
Department to get the nearest authorized service center.
 A thermal overload protector will shut off the motor if the motor
temperature is too high. If this occurs, turn the switch off. Wait 5
minutes for the motor to cool. Turn switch on and resume operation.
 The tank may be full and needs to be emptied. See Figure 8.
 The wands, hose and nozzle may be clogged and need to be
cleaned.
 Any of the above may be damaged and need to be replaced.
 The filter may be clogged. Use the Filter Cleaning System (see figure
7), to clean the filter.
 Replace the filter or make sure the filter is installed properly.
 The hose connection is loose and need to be tightened.
 If the environment is too dry, add moisture to air. If possible, use a
humidifier.
 In case the relative humidity of air is low, please note that this
situation will not have any effect on use of the vacuum cleaner.