Table of Contents
Advertisement
Replacing
Conveyor Belt
Replacing the conveyor belt is a relatively simple
process, but it will require re-tensioning and track-
ing once the new conveyor belt is installed.
Items Needed
Wrench 12mm ................................................... 2
Hex Wrench 6mm .............................................. 1
An Assistant ...................................................... 1
To replace conveyor belt:
1.
DISCONNECT MACHINE FROM POWER!
2.
Use a permanent marker to mark the front of
the conveyor belt adjustment bolt (see Figure
40) on both sides. This step will aid you in
returning the bolts to their original position,
reducing the amount of tracking necessary.
Loosen lock nuts shown in Figure 40. Turn
3.
both of the conveyor belt adjustment bolts
counterclockwise one full turn at a time to
release tension from feed belt.
Lock Nut
Figure 40. Conveyor belt tensioning controls.
-36-
Qty
Conveyor Belt
Adjustment
Bolt (1 of 2)
4.
Remove outside table cap screws shown in
Figure 41 and loosen corresponding cap
screws on inside edge.
Figure 41. Feed belt table outside cap screws.
5.
Have an assistant lift outside edge of the
table, then slide conveyor belt off.
6.
Clean any dirt or dust off of table and rollers,
have an assistant lift the table, then slide the
new conveyor belt on.
7.
Re-install and tighten all of the table cap
screws.
8.
Tighten conveyor belt adjustment bolts
equally, then follow tensioning instructions
on Page 35.
Note: The conveyor belt will stretch slightly
when new and will need to be re-tensioned
after a short amount of use.
9.
Track new conveyor belt according to instruc-
tions on Page 34.
Note: One side of the belt may need to be
tighter than the other for the belt to track
straight.
Model G0458Z (Mfd. Since 01/23)
Table Cap
Screws
Advertisement
Table of Contents
