Grizzly G0458ZX Manual page 13

Replacing
Sandpaper
The Model G0458ZX is designed for 3" wide,
hook-and-loop sandpaper rolls.
Items Needed
Hex Wrench 5mm .............................................. 1
Phillips Screwdriver #2 ...................................... 1
Sandpaper Roll, Hook-and-Loop 3" x 86" ......... 1
Utility Knife ........................................................ 1
Filament Tape ⁄ " .............................. As Needed
3
4
To replace sandpaper:
DISCONNECT MACHINE FROM POWER!
1.
Remove cap screw and flat washer (see
2.
Figure 17), then open top cover.
Figure 17. Location of top cover cap screw.
Model G0458ZX (Mfd. Since 11/23)
OPERATION
3.
Qty
4.
Remove (3) flat head screws as shown in
Figure 18, then remove chip deflector pate.
x 3
Chip Deflector Plate
Figure 18. Location of chip deflector plate.
Remove tape from left end of drum (see
Figure 19), then carefully unwrap sandpaper
from drum; loosen flat head screw to release
clip on right side of drum to remove sandpa-
per completely.
Filament Tape
Figure 19. Location of sandpaper fasteners.
Sandpaper Clip
-13-