Table of Contents
Advertisement
Copying the setting from connector to batteries
1.
Install the battery cartridge which you want to copy your setting from the connector. (The mode lamp lights up in
red.)
NOTE: If you want to copy your setting to the battery cartridge, which has been used as a power supply during the
setting in the stand-alone mode, take it away from the connector and then install it again.
2.
The setting that you configured in the stand-alone mode will be copied to the battery cartridge.
NOTE: A beep sounds after the copy has been completed.
NOTICE:
A series of short beeps sound when the copy fails. In this case, remove the battery cartridge
from the connector. Check the settings such as the current PIN, and then re-install it.
If copying still fails, change the operation mode of the connector to "Comm Mode" once, and check the
settings of the battery cartridge.
Copying the setting from connector to tools
1.
Install a battery cartridge to the communication connector. (The mode lamp lights up in green.)
2.
Install the tool which you want to copy your setting from the connector.
3.
Your setting will be copied onto the tool.
NOTE: A beep sounds after the copy has been completed.
NOTICE:
Do not remove the battery cartridge while the setting is being copied to the tool.
NOTICE:
A series of short beeps sound when the copy fails. In this case, remove the tool and battery
cartridge from the connector. Check the settings such as the current PIN, and then re-install them.
If copying still fails, change the operation mode of the connector to "Comm Mode" once, and check the
settings of the tool.
26 ENGLISH
Advertisement
Table of Contents
