Makita DKP180 Instruction Manual page 11

► 1 . Blade edge 2. Cutting line
Draw a cutting line on the workpiece. Insert the edge
fence into the hole in the front of the tool. Align the
blade edge with the cutting line.
1
► 1 . Screw 2. Edge fence (optional accessory)
Adjust the edge fence until it comes in contact with the
side of the workpiece, then secure it by tightening the
screw.
When planing, move the tool with the edge fence flush
with the side of the workpiece. Otherwise uneven plan-
ing may result.
Maximum shiplapping (rabbeting) depth is 9 mm
(11/32").
2
1
2
11 ENGLISH
You may wish to add to the length of the fence by
attaching an extra piece of wood. Convenient holes
are provided in the fence for this purpose, and also for
attaching an extension guide (optional accessory).
Chamfering
To make a chamfering cut as shown in the figure, align
the "V" groove in the front base with the edge of the
workpiece and plane it.