Table of Contents
Advertisement
6.
If the engine oil is below the "L" level
mark, add sufficient oil of the recom-
mended type to raise it to the "H" level
mark. (See page 122 for the recommend-
ed oil.) NOTICE: When adding the en-
gine oil, be careful not to fill above the
"H" level mark on the dipstick. Use
only the recommended oil. (See page
122.) Make sure that no foreign materi-
al enters the engine oil tank.
7.
Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
8.
Connect the oil level gauge coupler.
9.
Install the right side cover and the shroud,
or close the shroud.
To change the engine oil (with or with-
out oil filter cartridge replacement)
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Start the engine, warm it up for several
minutes, and then turn it off.
3.
Remove the shroud, the right side cover,
and the top cover [RS90P / RS90PLT /
RST90PGT (see page 62 for the proce-
dures)], or open the shroud and remove
the right side cover [RST90 (see page 66
for the procedures)].
4.
Remove the screws and the bolts, and
then pull the right lower cover outward to
remove
it
RST90PGT).
Periodic maintenance and adjustment
[ECS00462]
(RS90P /
RS90PLT /
RS90P / RS90PLT / RST90PGT
3
1
1. Screw
2. Bolt
3. Right lower cover
5.
Remove the bottom panel by removing
the bolts.
1. Bolt
2. Bottom panel
6.
Place an oil pan under the oil tank to col-
lect the used oil.
7.
Disconnect the oil level gauge coupler.
1
2
2
1
79
Advertisement
Table of Contents
