Makita GRH10 Instruction Manual page 13

To place the cap back to the original position, follow the
steps below.
1.
Turn the bellows counterclockwise and remove it
from the dust cup set attachment unit while the bellows
is unlocked.
Fig.23
► 1 . Bellows 2. Attachment unit
2. Set the cap back in place with its lettered side
facing upwards.
2
1
Fig.24
► 1 . Cap 2. Attachment unit
3. Be sure that the grooves around the cap well fit in
the lips of the upper opening of the attachment unit.
Tool hanger
Optional accessory
CAUTION:
Do not use damaged tool hanger
and screw. Before use, always check for dam-
ages, cracks or deformations, and make sure that
the screw is tightened.
CAUTION:
Install or remove the tool hanger
on a stable table or surface. Be sure to use the
screw provided with the tool hanger only. After
installing the tool hanger, make sure that the tool
hanger is securely installed with the screw.
CAUTION:
Do not remove the battery car-
tridge while hanging the tool. The tool may fall if the
screw is not tightened.
1
2
The tool hanger is intended for connecting the lanyard
(tether strap).
Before installing the tool hanger, remove the rubber cap
from the screw hole in the mounting bracket. Insert the
square nut under the bracket. Tighten the tool hanger
with screw in place.
1
2
2
3
Fig.25
► 1 . Rubber cap 2. Mounting bracket 3. Square nut
4. Tool hanger 5. Screw
Safety warnings about connecting
lanyard (tether strap) to the tool
hanger
Safety warnings specific for use at height
Read all safety warnings and instructions. Failure
to follow the warnings and instructions may result in
serious injury.
1. Always keep the tool tethered when working
"at height". Maximum lanyard length is 2 m
(6.5 ft).
The maximum permissible fall height for lan-
yard (tether strap) must not exceed 2 m (6.5 ft).
Do not anchor the tool lanyard to anything on
2.
your body or on movable components. Anchor
the tool lanyard to a rigid structure that can
withstand the forces of a dropped tool.
Make sure the lanyard is properly secured at
3.
each end prior to use.
4. Inspect the tool and lanyard before each use
for damage and proper function (including
fabric and stitching). Do not use if damaged or
not functioning properly.
Do not wrap lanyards around or allow them to
5.
come in contact with sharp or rough edges.
6. Fasten the other end of the lanyard outside
the working area so that a falling tool is held
securely.
7. Attach the lanyard so that the tool will move
away from the operator if it falls. Dropped tools
will swing on the lanyard, which could cause injury
or loss of balance.
8. Do not use near moving parts or running
machinery. Failure to do so may result in a crush
or entanglement hazard.
13 ENGLISH
4 5
1