Makita GRH10 Instruction Manual page 10

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Side grip (auxiliary handle)
CAUTION:
Always use the side grip to ensure
safe operation.
CAUTION:
After installing or adjusting the
side grip, make sure that the side grip is firmly
secured with the protrusions on the tool are fully
engaged by the grooves on the side grip.
To install the side grip, follow the steps below.
1.
Loosen the thumb screw on the side grip.
1
Fig.9
► 1 . Thumb screw
2. Install the side grip so that the grooves on the
grip fit in the protrusions on the tool while pressing the
thumb screw.
Fig.10
► 1 . Thumb screw
3. Tighten the thumb screw to secure the grip. The
grip can be fixed at desired angle.
To remove the side grip, loosen the thumb screw on the
side grip. Remove the side grip from the tool.
1
Installing or removing drill bit
Grease
Clean the shank end of the bit and apply grease before
installing the bit.
Coat the shank end of the bit beforehand with a small
amount of grease (about 0.5 - 1 g). This chuck lubrica-
tion assures smooth action and longer service life.
1
Fig.11
► 1 . Shank end 2. Grease
Insert the drill bit into the tool. Turn the drill bit and push
it in until it engages.
After installing the drill bit, always make sure that the
drill bit is securely held in place by trying to pull it out.
1
Fig.12
► 1 . Drill bit
To remove the drill bit, push the chuck cover down all
the way and pull the drill bit out.
Fig.13
► 1 . Drill bit 2. Chuck cover
10 ENGLISH
2
1 1
2 2