Cisco Small Business Pro SPA500S Quick Start Manual page 3

Step 4 Using the attachment arm screw, secure the attachment arm to
the first SPA500S.
Step 5 Align the right screw hole in the second SPA500S with the
unused hole on the attachment arm.
Step 6 Insert the pegs on the attachment arm into the peg holes on the
SPA500S.
Step 7 Using the attachment arm screw, secure the attachment arm to
the second SPA500S.
C
AUTION
Do not plug a telephone line cord into the AUX port. Use only the auxiliary
cable provided with the SPA500S.
Step 8 Locate the AUX OUT port on the back of the first SPA500S. Connect
one end of the auxiliary cable to this port.
Step 9 Locate the AUX IN port on the back of the second SPA500S.
Connect the other end of the auxiliary cable to this port.
Step 10 Route the auxiliary cable inside the cable slot. The SPA500S is
powered by the auxiliary cable with the SPA500 Series IP Phone; no
additional power source is required.
Step 11 Attach the appropriate desktop stands to each unit.
Using t he S PA500S
You can press a button on the SPA500S to dial an associated line, pick up
a call ringing at a line, or transfer a call to the line.
N
OTE
The options available on the SPA500S depend on the phone system
configuration. Your phone system might not provide all of the features
mentioned in this document.
Monitoring Lines
The LED color of a line button gives you information about the line being
monitored:
Green: The line is idle.
•
Red (steady): The line is in use.
•
• Red (blinking): The line is ringing.
• Orange (steady): The line is not registered; there is a problem with
phone connectivity.
Orange (blinking): The line is not configured properly.
•
Off: The line is not configured.
•