Connecting A Vcr And Cable Tv - Sony WEGA KLV-15SR1 Operating Instructions Manual

Installing and Connecting the TV

Connecting a VCR and Cable TV

12
Use this hookup if:
• You have cable TV that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the VCR's IN jack.
2
Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
3
Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S
VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
Rear of TV
75-ohm
coaxial
cable
(supplied)
VHF/UHF R-AUDIO-L
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
Note
To watch the pictures input from the S VIDEO input jack, set "Auto YC" to "On" in the
(Setup) menu (See below).
Tip
If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
When connecting both VIDEO OUT and S VIDEO OUT
You can select which jack the TV receives the input signal from on the menu
screen. The TV is factory set to receive S VIDEO input signals.
1
Press TV/VIDEO repeatedly to select VIDEO 1 IN.
2
Press MENU.
3
Press V/v to select
4
Press V/v to select "Auto YC," then press
5
To watch the pictures input from the S VIDEO input jack:
Press V/v to select "On," then press
To watch the pictures input from the VIDEO input jack:
Press V/v to select "Off," then press
6
Press MENU to exit the menu screen.
VIDEO S VIDEO R-AUDIO-L Y P P
B
VIDEO 1 IN VIDEO 2 IN
VCR
S VIDEO
VMC-810S/820S
(not supplied)
YC-15V/30V (not supplied)
(Setup), then press
75-ohm
coaxial cable
(supplied)
R L DC IN 16.5V
R
AUDIO OUT
.
.
.
.
Cable