Connecting A Vcr And Cable Tv - Sony KLV-15SR1 Operating Instructions Manual

Install ng and Connecting the IV
Connecting a VCR and Cable TV
Use this hookup if:
• You have cable TV that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the VCR's IN jack.
2 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
3 Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S
VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
Rear of TV
12
AUDIO-R (red) ,,._
AUDIO-L (white) -_/'_
VIDEO (yellow)_---_
• oS VIDEO
VMC-810S/820S 3
(not suppliid ) .-
75-ohm
coaxial cable
(supplied)
VCR
AI/OIO R idJmO L _EEO 8 VIDEO OUT[_ I
?
Cable
YC-15V/30V (not supplied)
Note
To watch the pictures input fi'om the S VIDEO input jack, set "Auto YC" to "On" in the
(Setup) menu (See below).
Tip
if your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
When connecting both VIDEO OUT and S VIDEO OUT
You can select which jack the TV receives the input signal from on the menu
screen. The TV is factory set to receive S VIDEO input signals.
1
Press TV/V1DEO repeatedly to select VIDEO 1 IN.
2
Press MENU.
:3 Press _/t_ to select _ (Setup), then press (SZ).
4. Press _/t_ to select "Auto YC," then press (_).
5 To watch the pictures input from the S VIDEO input jack:
Press _/t_ to select "On," then press (!).
To watch the pictures input from the VIDEO input jack:
Press _/t_ to select "Off," then press (:Z).
6 Press MENU to exit the menu screen.