Connecting A Satellite Receiver - Sony WEGA KLV-15SR1 Operating Instructions Manual

Connecting a Satellite Receiver

75-ohm
coaxial
cable
(supplied)
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
2
Using AUDIO and S VIDEO cables, connect the satellite receiver's AUDIO
and S VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
3
Connect the supplied 75-ohm coaxial cable from your cable or antenna to the
TV's VHF/UHF jack.
Rear of TV
VHF/UHF R-AUDIO-L VIDEO
VIDEO 1 IN
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
Note
To watch the pictures input from the S VIDEO input jack, set "Auto YC" to "On" in the
(Setup) menu (See page 12).
Tip
If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow) instead
of the S VIDEO cable.
S VIDEO R-AUDIO-L Y P P R
B R
VIDEO 2 IN AUDIO OUT
S VIDEO
VMC-810S/820S
(not supplied)
YC-15V/30V (not supplied)
Installing and Connecting the TV
L DC IN 16.5V
Satellite receiver
Satellite
antenna
cable
13