Operation - Makita 3706 Instruction Manual

CAUTION:
• Do not tighten the collet nut without inserting a
bit, or the collet cone will break.
• When using the bit with 6.35 mm (1/4") shank diam-
eter, first replace the collet cone 3.18 mm (1/8") with
the collet cone 6.35 mm (1/4"), then install the bit.
To install the bit, insert the bit all the way into the collet cone.
Press the shaft lock to keep the shaft stationary and use
the wrench to tighten the collet nut securely.
To remove the bit, follow the installation procedure in reverse.
Changing the collet cone
1 2
2
► 1. Collet nut 2. Collet cone
CAUTION:
• Use the correct size collet cone for the bit which
you intended to use.
• Do not tighten the collet nut without inserting a
bit, or the collet cone will break.
To change the collet cone, loosen the collet nut and
remove. Remove installed collet cone and replace with
desired collet cone. Reinstall collet nut.

OPERATION

CAUTION:
• Avoid forcing the bit to bend or twist. It may snap.
• Before turning the tool on, make sure the bit and
collet nut are securely tightened.
Hold the tool secure with the bit pointing in a safe direc-
tion not contacting any surface and slide the switch to
the ''ON'' position. Wait until the tool attains full speed.
When starting the multipurpose bit into the material,
hold the tool at approximately a 45 degree angle with
the edge of the shoe base contacting the material.
Carefully bring the tool to a straight position so the shoe
base is in full contact with the material.
When inserting the drywall guide bit into the drywall,
carefully insert the bit straight until the shoe base is in
full contact with the material.
Move the tool slowly with a constant pressure in a
clockwise direction to make the cut.
When cutting straight line, clamp a straight board firmly
to the material and use it as a guide. Move the tool in
the direction of the arrow with the shoe base flush with
the side of the guide board.
When the cut is complete, turn the tool off and wait for
the bit to stop rotating and then carefully remove it from
the material.
5 ENGLISH